Common Failures Of WINCOR Printers

- Mar 11, 2018-

One, the phenomenon ERROR lights once, after two seconds to light again. The cause of the problem

It may be a cutter fault.


Two. The phenomenon ERROR lights two times. After two seconds, the light is repeated. The cause of the problem.It may be the sensor failure of the print head.


Three, the phenomenon ERROR lights three times, after two seconds to repeat. The cause of the problem is that the print head can not be reset, it may be a print head cable failure or there is a Paper scraps.


Four, the phenomenon ERROR lights four times, after two seconds to repeat. The cause of the problem may be that the cover of the printer is not covered, or the printer's cover is next to the cover.

The fault of the sensor.


Five, the phenomenon ERROR lights seven times, after two seconds to repeat. The cause of the problem

It may be that the print head is overheated. Change the print head.Second pages of 8 pages

Six, the phenomenon ERROR light flicker two times, and then a long time. The cause of the problem

It may be that the voltage of the printer is too high. Replace the main board.


Seven, the phenomenon ERROR lights flashing three times, and then a long time. The cause of the problem

It may be that the voltage of the printer is too low.


Eight, the phenomenon ERROR lights a long time, after two seconds to repeat. The cause of the problem

It may be a transformer fault.